Remote Control Cards
Remote Control Cards Remote Control Cards gives the member the opportunity for real-time card management. Credit Union must purchase the FLEX Mobile App in order to add the Remote Control Cards feature.
The setup for Remote Control Cards can take up to 4 weeks. Once setup is complete the member will have access to mark cards as Active, Disabled, Lost or Stolen. These options are configured by the credit union so that they are not a part of the member’s options. Lost/Stolen flagged cards may not be reactivated on the app.
Requirements for Remote Control Cards:
- Release 8.02 or higher
- FLEX Mobile
- Remote Control Cards Module
- Recommended to have Processor Hot Carding feature (can be done without but there are timing issues without this option).
Once setup is complete, there will be an option in the Mobile Banking menu for Debit/Credit Cards.
Once selected, each card will display and show the current status.
Member can select the card they would like to change the status and update. A message will display confirming the member’s selection.
A block code is placed on the card in Card Maintenance. If the credit union is using Hot Carding, the block code is sent real-time to the card processor. If the credit union does not have Hot Carding, the message does not go to the processor and the block is only on the system.
If communication goes down between FLEX and the card processor, putting the credit union in stand-in mode, the processor would not be aware of the block and transactions would be approved and post when communication resumes.
The member can change the status from Active to Disabled and back. If the member changes the card status to Lost or Stolen, they cannot change it back to active. Once the member changes the status to Lost or Stolen, they will need to contact the credit union to get a new card or to have the credit union remove the block code, if it was added in error. Lost/Stolen options can be excluded from member’s options, if desired.
A report is generated at End of Day for the credit union to review. This report shows every block placed that day, either by a teller or by the member through the app. If a teller placed/removed the block, the teller who maintained the block is displayed. If the member placed/removed the block, the type of device used is displayed (Apple, Android or other). If the credit union does not have Hot Carding, they could use this report to manually enter blocks in their card processor’s system.
Confidentiality Notice: This document is published by Computer Marketing Corporation/FLEX and is intended solely for its contracted clients. It may contain information that is privileged, confidential or otherwise protected from disclosure. Dissemination, distribution or copying of this document and any accompanying attached information by someone other than the intended recipient(s), or an employee or agent acting on behalf of the intended recipient, is strictly prohibited.